Materials Portal Logo MATERIALS PORTAL

EN AW-Al Mg4,5 | EN AW-5082 Material Datasheet

Unlock Exclusive Materials Data

Gain access to a wealth of materials data by joining our Materials Portal.

Register for Free or Upgrade for Full Access

Material Description

Material Number Material Number (single) Standard Range of Application Standard Status Country Successor
EN AW-5082 (DIN EN 573-3 : 2003-10) EN AW-5082 DIN EN 573-3 : 2003-10 DIN EN 573-3 : 2003-10 replaced by DIN EN 573-3 : 2007-11 Replaced Germany EN AW-Al Mg4,5 1)
1) Remark: The food-safe material EN AW-Al Mg4,5 is produced as prematerial for cans, caps and stoppers as well as for wire and prewire for mechanical application. To the comparable mark AlMg4,5, material No. 3.3345, acc. to DIN 1725-1 :1983-02 applies: The alloy has a high corrosion resistance. It is resistant to seawater and salted atmosphere. Strength increases and cold workability decreases according to the Mg-content. The alloy is naturally hard, i.e. a strength increase is achieved only by cold forming not by controlled heat treatment. The material is well brightenable and suitable for anodizing. Cutting workability and weldability increase according to the rising Mg-content. It shows an intercrystalline corrosion sensitivity. Tendency to intercrystalline corrosion can be decreased by appropriate heat treatment or addition of Mn or Cr. Application: predominantly for packaging

Chemical Composition

Cr [%] Cu [%] Fe [%] Mg [%] Mn [%] Si [%] Ti [%] Zn [%]
blur blur blur blur blur blur blur blur 1)2)
1) Source: blur
2) Remark: blur

Cross Reference

Material Name Country Standard
5082 Australia AS 2848.1
5082 France NF A50-481
A-G4,5 France NF A50-481
AA 5082 USA International Registration Record (AA)
A5082P Japan JIS H 4000
3.5058.00 Yugoslavia JUS C.C2.100
AlMg4,5 Yugoslavia JUS C.C2.100
AlMg4,5 Turkey TS 412
A95082 USA UNS
AlMg4,5 (3.3345) Germany DIN 1725-1

Producer/Supplier/Trade names

Tradename Supplier
EN AW-Al Mg4,5 Wieland Prometa GmbH, Düsseldorf

Material Compliance

REACh RoHS
blur blur

Linear-elastic

Temperature [°C] Young's modulus [GPa] Bulk modulus [GPa] Shear modulus [GPa] Poisson's ratio
blur blur blur blur blur
blur blur blur blur blur
blur blur blur blur blur

Classification

WIAM Material Treatment Semi-finished product Dimension [mm] Load type Failure criteria Rolling direction Maximum stress [MPa] Strain at maximum stress [%] Source description
blur blur blur blur blur blur blur blur blur blur

Designation

Designation Material number Source
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur