Materials Portal Logo MATERIALS PORTAL

EN AW-Al 99,9Mg1 | EN AW-5505 Material Datasheet

Unlock Exclusive Materials Data

Gain access to a wealth of materials data by joining our Materials Portal.

Register for Free or Upgrade for Full Access

Material Description

Material Number Material Number (single) Standard Range of Application Standard Status Country Successor
EN AW-5505 (DIN EN 573-3 : 2003-10) EN AW-5505 DIN EN 573-3 : 2003-10 DIN EN 573-3 : 2003-10 replaced by DIN EN 573-3 : 2007-11 Replaced Germany EN AW-Al 99,9Mg1 1)
1) Remark: Material EN AW-Al 99,9Mg1is produced for centre punching. The alloy is used for sheet metal, strip, plates and as wire resp. prewire for mechanical applications. It is food-safe. To the comparable mark Al99,9Mg1, material No. 3.3318, acc. to DIN1725-1 : 1983-02 applies: The alloy Al99,9Mg1 pertains to standardized bright materials. It is able to be chemical or electrolytic high-polished after mechanical polish. There necessarily has to be a following anodizing, if the high-polished surface should be appropriate applicated. The intensity of the directional reflection (gloss level) depends on cleanliness of the alloy and thickness of the obtained anodizing layer. The alloy Al99,9Mg1 is naturally hard, i.e. a strength increase can only be achieved by cold forming. The material is ideal for cold and warm forming. It is highly resistant to corrosion and well anodic oxidizable. Application: for metal goods, such as building hardware, harness, extruded parts, reflectors, car trim parts and strip and for jewelry and jeweler goods.

Chemical Composition

Fe [%] Mg [%] Mn [%] Si [%] Ti [%] Zn [%]
blur blur blur blur blur blur 1)2)
1) Source: blur
2) Remark: blur

Cross Reference

Material Name Country Standard
EN AW-Al 99,9Mg1 USA AA 5505
A95505 USA UNS
Al99,9Mg1 (3.3318) Germany DIN 1725-1

Material Compliance

REACh RoHS
blur blur

Linear-elastic

Temperature [°C] Young's modulus [GPa] Bulk modulus [GPa] Shear modulus [GPa] Poisson's ratio
blur blur blur blur blur
blur blur blur blur blur
blur blur blur blur blur

Classification

WIAM Material Treatment Semi-finished product Dimension [mm] Load type Failure criteria Rolling direction Maximum stress [MPa] Strain at maximum stress [%] Source description
blur blur blur blur blur blur blur blur blur blur

Designation

Designation Material number Source
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur