Materials Portal Logo MATERIALS PORTAL

EN AW-Al 99,5(A) | EN AW-1350A Material Datasheet

Unlock Exclusive Materials Data

Gain access to a wealth of materials data by joining our Materials Portal.

Register for Free or Upgrade for Full Access

Material Description

Material Number Material Number (single) Standard Range of Application Standard Status Country Predecessor Successor
EN AW-1350A (DIN EN 573-3 : 2009-08) EN AW-1350A DIN EN 573-3 : 2009-08 DIN EN 573-3 : 2009-08 replaced by DIN EN 573-3 : 2013-12 Replaced Germany EN AW-Al 99,5 EN AW-Al 99,5(A) 1)
1) Remark: Material EN AW-EAl 99,5(A) is produced in a limited amount for sheet, strips and plates. It is food-safe. To the comparable mark E-Al, mat. No. 3.0257, acc. DIN 1712-3 : 1976-12 (invalid) applies: Declarated by the German Electical Engineering Commission (Deutsche Elektrotechnische Kommission) as alloy for electrical engineering with a warranted electrical conductivity acc. to DIN 40 501 part 1 to part 4. This material shows a favorable electrical and thermal conductivity but only low mechanical strength. Reformability and chemical as well as weathering resistance are very good. Application: roll bond, Z-Bond, cable straps of particularly high requirements.

Chemical Composition

Cu [%] Fe [%] Mg [%] Si [%] Ti [%] Zn [%]
blur blur blur blur blur blur 1)2)
1) Source: blur
2) Remark: blur

Cross Reference

Material Name Country Standard
1350A USA International Registration Record (AA)
A91350 USA ASTM B 230
A91350 USA ASTM B 231
A91350 USA ASTM B 233
A91350 USA ASTM B 236
A91350 USA ASTM B 324
A91350 USA ASTM B 401
A91350 USA ASTM B 524
A91350 USA UNS

Producer/Supplier/Trade names

Tradename Supplier
EN AW-E Al99,5(A) Martinrea Honsel Germany GmbH, Meschede
EN AW-EAl99,5(A) TRIMET ALUMINIUM AG, Essen

Material Compliance

REACh RoHS
blur blur

Linear-elastic

Temperature [°C] Young's modulus [GPa] Bulk modulus [GPa] Shear modulus [GPa] Poisson's ratio
blur blur blur blur blur
blur blur blur blur blur
blur blur blur blur blur

Classification

WIAM Material Treatment Semi-finished product Dimension [mm] Load type Failure criteria Rolling direction Maximum stress [MPa] Strain at maximum stress [%] Source description
blur blur blur blur blur blur blur blur blur blur

Designation

Designation Material number Source
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur
blur blur blur